Drawings and documents
Published accounts: specification
Specification printed in the Journal of the Franklin Institute
Journal of the Franklin Institute, new ser., vol. 12 (1833), p. 259 · View the page
Text of the specification as printed in the Journal, from OCR; not proofread.
Specification of a patent for machinery for washing pulp in manufacturing paper. Granted to FRANCIS GOUCHER, Chester county, Pennsylvania, April 12, 1833. To all whom it may concern, be it known, that I, Francis Goucher, of Chester county, in the state of Pennsylvania, have invented an improvement in the machinery for washing the pulp, in the manufacturing of paper, and that the following is a full and exact description thereof. I make an opening in the side, or end, of the washing, or beating, engine, wherever the most convenient or advantageous application of power can be made, and insert a brass or copper vellum of any number to suit the quality of rags to be washed, and sufficiently large, (my present one being fifteen by twenty inches,) to allow a passage for all the water necessary for the operation of washing; and in order to obviate the suction which would arise from having the vellum only in the engine, I attach a box to the outer part of the engine opposite the vellum, and in this box fix a hog, or vertical paddle wheel, the use of GOUCHER'S Pulp Washer. which is to agitate the water against the vellum and drive the rags from contact with it, by which a space is obtained within the engine free from the rags, and an unobstructed passage of the water allowed. The paddles on the wheel are placed at an angle of about forty-five degrees with the arms which pass through the shaft and to which the paddles are attached this position of the paddles capacitates them for throwing the water more forcibly against the vellum within the box, than by having them (as in the common hog for suspending the pulp in vats,) perpendicular to the shaft. The discharge of the water through the vellum is regulated by a gate in the side of the box, fixed near the top so as to prevent the water sinking below the required height in the engine-otherwise the capacity for discharging the water from the box being greater than the means of supplying the engine, suction would ensue, and thus the function of the hog be counteracted-the skill and attention of the workman must be relied on for the performance of this part of the operation. The suspension of the process of washing is effected by closing the aperture in the box by the gate, and allowing the water to remain stationary therein, at the height required in the engine. It is important that the box should be perfectly water-tight, and for the better securing of this it should be composed of metal, (copper for instance,) or if of wood it should be lined with copper or lead, and soldered at the joints; otherwise a leaking would, by lowering the water in the box, cause, more or less, a constant suction at the vellum, and thereby arrest the pulp in the process of beating; but this inconvenience can be remedied by having the vellum so fixed as to slide in and out of the engine, and a brass or copper plate substituted for it when it is required to stop the washing. In this form of the vellum another advantage would be gained-two or more frames of vellum of different numbers to suit the progressive stages of the rags, could be used, and thus by using first the coarser number of vellum, to allow the more free expulsion of large particles of matter that may be to be washed out of the rags, and then the finer vellum as the state of the rags may admit. My present box is two feet in length, one foot six inches in breadth, and one foot six inches in height; the vellum in the engine is fifteen inches wide and twenty inches long; this may be varied to suit the size of the engine, &c.; the number of the vellum is thirty, but may be coarser or finer to answer the first and progressive stages of the rags. The revolutions of the hog are eighteen to twenty per minute, which I consider the best velocity for preventing suction, and producing a smooth current in the discharge of the water through the vellum. The paddles of the hog are thirteen inches long, and four inches wide, and the diameter of the hog, from the extent of the paddles, thirteen inches. To prevent the agitation of the water at the aperture of the gate, by which its free discharge would be somewhat affected, I have constructed a box immediately around the hog inside of the other box, leaving a space between the two boxes of three inches wide at the discharging end, and two inches wide at the other extremity, and placed a bottom at three inches depth, being sufficient to carry off all the water which passes through the vellum. The water GOUCHER'S Pulp Washer. rises and flows over the top of the inner box into the box or trough which surrounds it, and thus a smooth stream passes through the gateway. Two or more of these boxes and hogs may be used at different parts of the engine when there is a greater supply of water than can be discharged through one, or the one may be extended in size at pleasure. The driving power may be obtained from the main works (as mine is at present) by small straps and pulleys, and when it is required to stop the hog, a loose pulley is the most convenient means. The bottom of the box should be three or four inches below that of the engine, to allow the settling of the discharged particles of dirt, &c. from the engine, and prevent their running again into the engine, when the hog is stopped-the dirt thus accumulated may be discharged from the box through a plug-hole in the bottom. What I claim as my invention, and for which I ask a patent, is the fixing of the vellum in the side of the washing, or beating vat, with a box, or reservoir, on the outer side of the vat opposite to the vellum; also the use of a revolving hog in said box, to dash the water forcibly against the vellum for the purpose of keeping it clear from the pulp, and thus allowing the water to pass unobstructed through it; and also the regulating slide, gate, or valve, in said box, or reservoir, to determine the quantity of water which shall flow through; resting my whole claim, not upon the particular parts, but upon the general arrangement of the apparatus as above described, whether the same be constructed in the exact manner herein set forth, or in any other operating upon the same principle, and producing a similar effect. FRANCIS GOUCHER. E JFI G G D H E C E H D D H D E A B A This drawing represents a horizontal section of the box, and of the hog, and other parts appertaining to it. A A, a part of the side of the vat. B, the edge of the vellum covering the opening between it and the box, represented by a dotted line. C, the axis of the hog. DD, arms carrying the dashers E E. FF, edges of the box. GG, edges of the interior box. HH, spaces for water. I, edge of the gate to regulate the flow of the water out of the box J, opening into, and through which, it flows after escaping by the gate.
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 12 (1833), p. 241 · View the page
21. For Washing Pulp in the manufacturing of Paper; Francis Goucher, Chester county, Pennsylvania, April 12.
Remarks. (See the specification.)
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- in_burke