Drawings and documents
Published accounts: specification
Specification printed in the Journal of the Franklin Institute
Journal of the Franklin Institute, new ser., vol. 6 (1830), p. 91 · View the page
Text of the specification as printed in the Journal, from OCR; not proofread.
Specification of a patent for a machine, denominated the "Facilitator," for the Napping of Hats. Granted to A. P. GREGORY, Ithaca, Tompkins county, New York, May 13th, 1830. THE Facilitator, or napping machine, is so constructed as to combine all the requisite properties of hand labour in making the nap penetrate the bodies of the hats, which are, motion, pressure, heat and wet. The hats are prepared in the usual way, by first sticking on the naps; they are then rolled up singly in the same way that they are rolled to work by hand (omitting the cloth that they are usually rolled in) and put into the machine while wet and hot, the machine standing on the plank kettle, the bottom resting on the rim of the same. The Facilitator is constructed as follows, and may ay be proportioned in size to the work intended to be done. For a machine which will carry 18 hats, or under, it should be 18 inches square at bottom, and 26 inches in height. The machine from the bottom, up, 13 inches, is divided into two equal parts, by an inch board, which is introduced at the bottom, and secured by nails passing through the sides of the machine, and into the ends of the board. Three inches above the upper edge of this board, which is 16 inches from the bottom, hangs a wooden shaft, ranging with the board below, on an axis one inch in diameter, to one end of which is attached a crank one foot in length. Through this shaft, and two inches from each side of the box, are two arms 17 inches in length; on the ends of the arms are two pieces of wood, one inch square and 15½ inches long; the shaft, arms and pieces on the ends of the arms, forming a frame which may be represented by two parallel lines, 17 inches long and 12 inches apart, for the arms; and at the extremities of these arms, two other parallel lines, 15 inches long, forming right angles with the two : GREGORY'S Machine for Napping Hats. first lines. Then draw a line across the two longest equi-distant from the ends, which represents the shaft, to one end of which the crank is attached. When in operation, the crank is moved by a vibrating motion, similar to the pendulum of a clock, with the exception that its vibration is longer, say about 170 degrees, and about as frequent as a time piece which beats half seconds. To the extremities of the arms, on the pieces of wood one inch in diameter, is fastened, by small tacks, a piece of coarse woollen cloth (lion skin) 1½ yards long, and 16 inches wide; the middle resting on the upper edge of the board by which the box is divided into two equal parts, to the edge of which it is fastened by nails, and hanging down into each apartment in the form of bags, into which the hats are put, through a door made for the purpose on the side of the machine opposite to the crank. By giving motion to the crank, the ends of the cloth being attached to the extremities of the arms, gives a rolling motion to the hats, and at every motion the bags with the hats go so low as to touch the water in the kettle, which keeps them sufficiently wet, and the machine confining the steam, keeps them much hotter than they can be worked by hand. It is necessary to take out the hats at the first as often as once in about 4 or 5 minutes to open them, or (to use a hatter's phrase) to crose them, to prevent the naps from running together; but towards the last, they may run twice that time. Hats may be sufficiently scalded in from 1 to 12 hours, according to the stock used and the number of hats worked at once. When as few as four hats are worked at one time, they should all be put into one side, but when more than 4 are worked, there should be as many put in one side as in the other. The top of the machine forms a half circle, the axis of the shaft being the centre. It is made separate from the bottom part, and attached to it by a pair of buts on the side of the machine opposite to the crank, and a small hook with two dowels on the side of the crank. A. P. GREGORY. A, (Fig. 1,) tight wooden box. B, (Fig. 2,) a frame placed across the box, supporting the cloth C. C, a cloth of woollen, fastened to the arms of the frame B; the middle of which is nailed to D, a perpendicular board reaching across the middle of the box, and making two apartments therein. E, a crank, by which the frame B is made to have a vibrating motion; this is shown in dotted lines, in Fig. 1, as is also Fig. 2. B Fig. 1. F E W D d GREGORY'S Machine for Napping Hats. the vibrating frame with its cloth, &c., the former being at the back, and the latter within the box. F, (Fig. 1,) the circular top of the box, with its hinges. The
Editor's remarks. This machine differs in form, from two others previously patented, one of which was noticed in our last number, as having issued on the 28th of April, to Mr. George Henning, and the other at p. 31 of our last volume, as patented by Mr. D. Baldwin. The resemblance between those of Baldwin and Henning would, we think, be apparent to any one, and, to us, it really appears that this of Mr. Gregory, is the same in principle; we have witnessed decisions in court establishing the identity of two machines which differed much more in the arrangement of their parts than do either of those now before us. There is one circumstance worthy of notice, namely, that all these three patentees are inhabitants of the same town, and the machines afford prima facie evidence of a commòn origin. Under such circumstances it is certain, that the only security which the patent law can afford to inventors must be derived from their claims being liberally viewed, and rigidly sustained by our courts of law. There are but few machines of any considerable complexity which we would not undertake so to modify and distort, that, to all common observers, they should appear to be essentially different, whilst, in fact, they remained essentially the same. modifications of the mechanical powers are numerous; one may frequently and readily be substituted for another, without affording the slightest claim to invention. If after a man has devised a machine, his neighbour may in this way rob him of his just dues with impunity, the patent law becomes a mere false light, to allure men to their destruction. Any one who has paid the strict attention to the progress of inventions which we have done, is well aware that whenever a machine which is, or appears likely to be, useful, is patented, it is immediately succeeded by numerous patents for modifications of the same thing, by men who swear that they really believe themselves to be the true and original inventors or discoverers. A custom house oath has been long a by-word, but really when persons who have only crooked a lever, or substituted a screw for a wedge, will swear that they have invented a machine, the sacredness of the averment must be as little felt, and its fallacy as palpable, as the testifying to a false invoice. Were we at liberty to do so, we could furnish some illustrative anecdotes, which might go far to change the reference from a custom house, to a patent office oath. Inventors frequently complain of the patent law, as affording them no security; the patent law is undoubtedly susceptible of much improvement, but after all the possible emendations have been made in this statute, its value must depend solely upon an enlightened jurisprudence.
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 6 (1830), p. 78 · View the page
13. For a machine to facilitate the Napping of Hats; A. P. Gregory, Ithaca, Tompkins county, New York, May 13.
Remarks. (See the specification.)
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 6 (1830), p. 90 · View the page
The internal pellicle, or skin, I rub off, and remove by triturating, or rubbing the shelled rice between a mill stone, commonly called the bed stone, and a runner (made of wood, or other substance,) faced with sheep skin, (with the wool on) or any other elastic substance, which presses the rice close against the bed stone, not so hard as to break the rice, but sufficiently so to cause the grain to be GREGORY'S Machine for Napping Hats. rubbed with a rapid motion against the stone, which takes off the extraneous substance from most of the grains, leaving the pearly substance of the grain bright and clear; this process is to be repeated, and the quality, or state of the rice, may be such as to require it to be passed through the machine three or more times, and to be screened and fanned between each operation. The rice is then, in the ordinary manner, to pass through screens, or fans, to the spout which delivers it into the barrel. The application of this invention may be varied by making the runners of stone, and the bed stone, (if I may so call it,) of wood, or other substance, faced with sheep skin, (with the wool on) or any other elastic substance, which will press, and keep the rice in close contact with the stone. The bed stone and runner, which I have used, are six feet in diameter, and move at the rate of 120 revolutions per minute, though I do not limit myself to any particular dimensions or speed, but I have found these to answer my purpose. JOHN L. NORTON. Specification of a patent for a machine, denominated the "Facilitator," for the Napping of Hats. Granted to A. P. GREGORY, Ithaca, Tompkins county, New York, May 13th, 1830.
Remarks. THE Facilitator, or napping machine, is so constructed as to combine all the requisite properties of hand labour in making the nap penetrate the bodies of the hats, which are, motion, pressure, heat and wet. The hats are prepared in the usual way, by first sticking on the naps; they are then rolled up singly in the same way that they are rolled to work by hand (omitting the cloth that they are usually rolled in) and put into the machine while wet and hot, the machine standing on the plank kettle, the bottom resting on the rim of the same. The Facilitator is constructed as follows, and may ay be proportioned in size to the work intended to be done. For a machine which will carry 18 hats, or under, it should be 18 inches square at bottom, and 26 inches in height. The machine from the bottom, up, 13 inches, is divided into two equal parts, by an inch board, which is introduced at the bottom, and secured by nails passing through the sides of the machine, and into the ends of the board. Three inches above the upper edge of this board, which is 16 inches from the bottom, hangs a wooden shaft, ranging with the board below, on an axis one inch in diameter, to one end of which is attached a crank one foot in length. Through this shaft, and two inches from each side of the box, are two arms 17 inches in length; on the ends of the arms are two pieces of wood, one inch square and 15½ inches long; the shaft, arms and pieces on the ends of the arms, forming a frame which may be represented by two parallel lines, 17 inches long and 12 inches apart, for the arms; and at the extremities of these arms, two other parallel lines, 15 inches long, forming right angles with the two : GREGORY'S Machine for Napping Hats. first lines. Then draw a line across the two longest equi-distant from the ends, which represents the shaft, to one end of which the crank is attached. When in operation, the crank is moved by a vibrating motion, similar to the pendulum of a clock, with the exception that its vibration is longer, say about 170 degrees, and about as frequent as a time piece which beats half seconds. To the extremities of the arms, on the pieces of wood one inch in diameter, is fastened, by small tacks, a piece of coarse woollen cloth (lion skin) 1½ yards long, and 16 inches wide; the middle resting on the upper edge of the board by which the box is divided into two equal parts, to the edge of which it is fastened by nails, and hanging down into each apartment in the form of bags, into which the hats are put, through a door made for the purpose on the side of the machine opposite to the crank. By giving motion to the crank, the ends of the cloth being attached to the extremities of the arms, gives a rolling motion to the hats, and at every motion the bags with the hats go so low as to touch the water in the kettle, which keeps them sufficiently wet, and the machine confining the steam, keeps them much hotter than they can be worked by hand. It is necessary to take out the hats at the first as often as once in about 4 or 5 minutes to open them, or (to use a hatter's phrase) to crose them, to prevent the naps from running together; but towards the last, they may run twice that time. Hats may be sufficiently scalded in from 1 to 12 hours, according to the stock used and the number of hats worked at once. When as few as four hats are worked at one time, they should all be put into one side, but when more than 4 are worked, there should be as many put in one side as in the other. The top of the machine forms a half circle, the axis of the shaft being the centre. It is made separate from the bottom part, and attached to it by a pair of buts on the side of the machine opposite to the crank, and a small hook with two dowels on the side of the crank. A. P. GREGORY. A, (Fig. 1,) tight wooden box. B, (Fig. 2,) a frame placed across the box, supporting the cloth C. C, a cloth of woollen, fastened to the arms of the frame B; the middle of which is nailed to D, a perpendicular board reaching across the middle of the box, and making two apartments therein. E, a crank, by which the frame B is made to have a vibrating motion; this is shown in dotted lines, in Fig. 1, as is also Fig. 2. B Fig. 1. F E W D d GREGORY'S Machine for Napping Hats. the vibrating frame with its cloth, &c., the former being at the back, and the latter within the box. F, (Fig. 1,) the circular top of the box, with its hinges.
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- Burke's 1847 Patent Office list gives the same patent.